Insidepenton Com Mrf Image01

VCOs Tune From 8.4 To 11.8 GHz

Nov. 8, 2011
Three additions to a line of voltage-controlled oscillators (VCOs) offer tuning frequencies through 11.8 GHz for a variety of microwave radio and communications applications. Models MAOC-009871, MAOC-009872, and MAOC-010334 cover frequency ranges of 9.2 ...
Three additions to a line of voltage-controlled oscillators (VCOs) offer tuning frequencies through 11.8 GHz for a variety of microwave radio and communications applications. Models MAOC-009871, MAOC-009872, and MAOC-010334 cover frequency ranges of 9.2 to 10.2 GHz, 11.0 to 11.8 GHz, and 8.40 to 9.25 GHz, respectively, with phase-noise levels of -113, -112, and -115 dBc/Hz, respectively, offset 100 kHz from the carrier. The three oscillators draw 185, 165, and 168 mA current, respectively, from a +5-VDC supply. They deliver at least +7 dBm output power from the main RF output port, and provide slightly lower power from a secondary output port. The oscillators are housed in lead-free, 5 x 5 mm, 32-lead PQFN packages.

M/A-COM Technology Solutions
100 Chelmsford St.
Lowell, MA 01851
(978) 656- 2500
(800) 366-2266

Sponsored Recommendations

Getting Started with Python for VNA Automation

April 19, 2024
The video goes through the steps for starting to use Python and SCPI commands to automate Copper Mountain Technologies VNAs. The process of downloading and installing Python IDC...

Introduction to Copper Mountain Technologies' Multiport VNA

April 19, 2024
Modern RF applications are constantly evolving and demand increasingly sophisticated test instrumentation, perfect for a multiport VNA.

Automating Vector Network Analyzer Measurements

April 19, 2024
Copper Mountain Technology VNAs can be automated by using either of two interfaces: a COM (also known as ActiveX) interface, or a TCP (Transmission Control Protocol) socket interface...

Guide to VNA Automation in MATLAB Using the TCP Interface

April 19, 2024
In this guide, advantages of using MATLAB with TCP interface is explored. The how-to is also covered for setting up automation language using a CMT VNA.