Image

Revolutionary sub-nA Transient Current Measurement

Sept. 15, 2016
Sponsored by Keysight Technologies
Traditional methods of measuring low-current AC waveforms using an oscilloscope have many limitations, including limited dynamic range, insufficient bandwidth and poor signal resolution. Keysight’s new CX3300 Device Current Waveform Analyzers overcome these limitations by providing a 1 GSa/sec sampling rate, up to 200 MHz of bandwidth and measurement resolution down to 100 pA.  A new application note uses NVM cell characterization examples to show how the CX3300's unique capabilities can reveal previously unseen device behavior.

DOWNLOAD APPLICATION NOTE

Sponsored Recommendations

Wideband MMIC LNA with Bypass

June 6, 2024
Mini-Circuits’ TSY-83LN+ wideband, MMIC LNA incorporates a bypass mode feature to extend system dynamic range. This model operates from 0.4 to 8 GHz and achieves an industry leading...

Expanded Thin-Film Filter Selection

June 6, 2024
Mini-Circuits has expanded our line of thin-film filter topologies to address a wider variety of applications and requirements. Low pass and band pass architectures are available...

Mini-Circuits CEO Jin Bains Presents: The RF Engine of the 21st Century

June 6, 2024
In case you missed Jin Bains' inspiring keynote talk at the inaugural IEEE MTT-S World Microwave Congress last week, be sure to check out the session recording, now available ...

Selecting VCOs for Clock Timing Circuits A System Perspective

May 9, 2024
Clock Timing, Phase Noise and Bit Error Rate (BER) Timing is critical in digital systems, especially in electronic systems that feature high-speed data converters and high-resolution...