Some Smart-Home Solution Demos Now Using the Matter IoT Standard

Jan. 19, 2023
Designed for smart homes and smart buildings, the Matter IoT ensures seamless interactions between connected devices across different IP platforms.

Designed for smart homes and smart buildings, the Matter IoT ensures seamless interactions between connected devices across different IP platforms. Matter is an application layer that addresses many applications in an open-source delivery and certification infrastructure.

Connected devices using Matter run based on Wi-Fi or Thread technologies, and each device has a specific role within the Matter network. These devices support a connectivity technology within Wi-Fi, Ethernet, or Thread as network communication protocol. Such devices also need to support Bluetooth LE (BLE) technology.

STMicroelectronics' STM32WB can run BLE and Thread in concurrent modes, which is necessary for device commissioning, with 1 MB of flash and 256 kB of RAM to support application layer and connectivity stacks. The Quad-SPI peripheral extends the memory size externally with execution in place, and can implement over-the-air firmware updates.

The STM32WB MCU comes with the NUCLEO-WB55RG and the discovery board STM32WB5MM-DK, which brings a wide feature set, including sensors, external flash, screen, and touch sensors for applications running on Matter.

For more information, CLICK HERE.

Alix Paultre | Editor-at-Large, Microwaves & RF
About the Author

Alix Paultre | Editor-at-Large, Microwaves & RF

Alix is Editor-at-Large for Microwaves & RF

An Army veteran, Alix Paultre was a signals intelligence soldier on the East/West German border in the early ‘80s, and eventually wound up helping launch and run a publication on consumer electronics for the U.S. military stationed in Europe. Alix first began in this industry in 1998 at Electronic Products magazine, and since then has worked for a variety of publications, most recently as Editor-in-Chief of Power Systems Design.

Alix currently lives in Wiesbaden, Germany.

Sponsored Recommendations

Aug. 21, 2025
Explore cascaded amplifiers, revealing how a single driver can dominate performance in a four-parallel setup and how optimized input power can reduce AM-to-PM distortion for maximum...
Aug. 21, 2025
See how an X-band SSB upconverter built with Mini-Circuits components uses IQ mixing to suppress unwanted sidebands and boost spectral efficiency for applications from 5G to radar...
Aug. 21, 2025
Mini-Circuits VP of Engineering Joe Merenda explains additive phase noise (APN) in RF amplifiers, covering theory, measurement, specifications, and small vs. large signal behavior...
Aug. 21, 2025
The new M4SWA4-34DR+ SP4T MMIC switch delivers fast, wideband signal routing from DC to 30 GHz, with superior power handling, quick switching, and cost advantages over SOI devices...