Pulse Modulators Switch In Under 500 ns

June 13, 2008
A COMPACT LINE of magnetron pulse modulators has been spawned to replace tube-based pulsers for highpower- radar transmitters delivering peak RF powers of 3 to 50 kW. The DTI PowerMod solid-state pulse modulators provide over 99 percent ...

A COMPACT LINE of magnetron pulse modulators has been spawned to replace tube-based pulsers for highpower- radar transmitters delivering peak RF powers of 3 to 50 kW. The DTI PowerMod solid-state pulse modulators provide over 99 percent switching efficiency. Depending upon load, pulse frequencies range up to 100 kHz. The modulators feature adjustable pulse widths from sub-microseconds to DC pulse to pulse. Under typical performance, the modules vow to reduce arc-energy to fractions of a joule. They extend magnetron transmitter life up to 50,000 hrs. mean time between failure (MTBF). Suitable for driving magnetrons across the L- to Ka-band frequency range, the modulators use standard circuit components and topologies. They measure 10 x 13 x 9 in. with custom configurations available. P&A: $30,000 to $200,000 depending upon system requirements.

Diversified Technologies, Inc., 35 Wiggins Ave., Bedford, MA 01730; (781) 275-9444, FAX: (781) 275-6081, Internet: www.divtecs.com.

See Associated Figure

Sponsored Recommendations

Guide to VNA Automation in MATLAB Using the TCP Interface

April 19, 2024
In this guide, advantages of using MATLAB with TCP interface is explored. The how-to is also covered for setting up automation language using a CMT VNA.

In-Circuit Antenna Verification

April 19, 2024
In this video, Brian Walker, Senior RF Design Engineer at Copper Mountain Technologies, shows how there can be significant variation of the performance of a PCB-mounted antenna...

UHF to mmWave Cavity Filter Solutions

April 12, 2024
Cavity filters achieve much higher Q, steeper rejection skirts, and higher power handling than other filter technologies, such as ceramic resonator filters, and are utilized where...

Wideband MMIC Variable Gain Amplifier

April 12, 2024
The PVGA-273+ low noise, variable gain MMIC amplifier features an NF of 2.6 dB, 13.9 dB gain, +15 dBm P1dB, and +29 dBm OIP3. This VGA affords a gain control range of 30 dB with...