9 Tips for optimizing your signal generator

Nov. 3, 2019

Tips for better signal generator measurements

In the crowded spectrum of consumer wireless, military communications and radar, precise, stable signal simulation to test your device is critical. Learn best practices to leverage the capabilities of your signal generator and optimize your testing for the most accurate measurements. Download the two-part application note 9 Best Practices for Optimizing Your Signal Generator.

Download Now

Continue Reading

Picking Proper PCB Materials For LNAs

Opting for Single-Layer or Multilayer Capacitors

Sponsored Recommendations

In-Circuit Antenna Verification

In this video, Brian Walker, Senior RF Design Engineer at Copper Mountain Technologies, shows how there can be significant variation of the performance of a PCB-mounted antenna...

UHF to mmWave Cavity Filter Solutions

Cavity filters achieve much higher Q, steeper rejection skirts, and higher power handling than other filter technologies, such as ceramic resonator filters, and are utilized where...

Wideband MMIC Variable Gain Amplifier

The PVGA-273+ low noise, variable gain MMIC amplifier features an NF of 2.6 dB, 13.9 dB gain, +15 dBm P1dB, and +29 dBm OIP3. This VGA affords a gain control range of 30 dB with...

Fast-Switching GaAs Switches Are a High-Performance, Low-Cost Alternative to SOI

While many MMIC switch designs have gravitated toward Silicon-on-Insulator (SOI) technology due to its ability to achieve fast switching, high power handling and wide bandwidths...