To Terminate or Attenuate? (.PDF Download)

Dec. 16, 2015

Attenuators and terminations are commonly-used components in high-frequency systems, used to adjust or absorb power, respectively. In many ways, the two types of components are similar, since they are both...

Register or sign in below to download the full article in .PDF format, including high resolution graphics and schematics when applicable.

Sponsored Recommendations

Wideband MMIC LNA with Bypass

Mini-Circuits’ TSY-83LN+ wideband, MMIC LNA incorporates a bypass mode feature to extend system dynamic range. This model operates from 0.4 to 8 GHz and achieves an industry leading...

Expanded Thin-Film Filter Selection

Mini-Circuits has expanded our line of thin-film filter topologies to address a wider variety of applications and requirements. Low pass and band pass architectures are available...

Mini-Circuits CEO Jin Bains Presents: The RF Engine of the 21st Century

In case you missed Jin Bains' inspiring keynote talk at the inaugural IEEE MTT-S World Microwave Congress last week, be sure to check out the session recording, now available ...

Selecting VCOs for Clock Timing Circuits A System Perspective

Clock Timing, Phase Noise and Bit Error Rate (BER) Timing is critical in digital systems, especially in electronic systems that feature high-speed data converters and high-resolution...