6 Degrees of Microwave and RF/Microwave Switch Separation (.PDF Download)

May 8, 2015

Before electronic control and actuation, mechanically actuated RF switches were used to re-route RF energy to different subsystems. Out of necessity, these switches were often custom, expensive, slow, and prone to failure. But they could handle significant amounts of RF energy...

Register or Sign in below to download the full article in .PDF format, including high resolution graphics and schematics when applicable.

Sponsored Recommendations

Explore cascaded amplifiers, revealing how a single driver can dominate performance in a four-parallel setup and how optimized input power can reduce AM-to-PM distortion for maximum...
See how an X-band SSB upconverter built with Mini-Circuits components uses IQ mixing to suppress unwanted sidebands and boost spectral efficiency for applications from 5G to radar...
Mini-Circuits VP of Engineering Joe Merenda explains additive phase noise (APN) in RF amplifiers, covering theory, measurement, specifications, and small vs. large signal behavior...
The new M4SWA4-34DR+ SP4T MMIC switch delivers fast, wideband signal routing from DC to 30 GHz, with superior power handling, quick switching, and cost advantages over SOI devices...