MIMO Testing: The Good and the Bad (.PDF Download)

Dec. 17, 2014

Multiple input multiple output (MIMO) devices make 4G performance possible through their ability to function in complex RF environments. Multiple antennas enable increased data throughput and quality of service without increasing transmission power or bandwidth. But these devices need testing systems capable of simulating various RF environments in a repeatable and controlled manner in order to find...

Register or Sign in below to download the full article in .PDF format, including high resolution graphics and schematics when applicable.

Sponsored Recommendations

Frequency Modulation Fundamentals

The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...

Using a CMT VNA with Socket Server

This application note describes use of a software application CMT Socket Server which is distributed and supported by Aphena Ltd. Please email [email protected] regarding purchase...