How to Set Up Oscilloscope Pulse-Width Triggering (Part 3)

Nov. 4, 2021
This part of the video series takes a look at using pulse width to trigger an oscilloscope.

This video is part of an Article Series: XYZs of Oscilloscopes.

In the 2nd video on triggering an oscilloscope, we look at pulse-width triggering, trigger hold-off and runt pulse triggers. These techniques will come in handy when capturing digital signals and bursts.

Sponsored Recommendations

Aug. 21, 2025
Explore cascaded amplifiers, revealing how a single driver can dominate performance in a four-parallel setup and how optimized input power can reduce AM-to-PM distortion for maximum...
Aug. 21, 2025
See how an X-band SSB upconverter built with Mini-Circuits components uses IQ mixing to suppress unwanted sidebands and boost spectral efficiency for applications from 5G to radar...
Aug. 21, 2025
Mini-Circuits VP of Engineering Joe Merenda explains additive phase noise (APN) in RF amplifiers, covering theory, measurement, specifications, and small vs. large signal behavior...
Aug. 21, 2025
The new M4SWA4-34DR+ SP4T MMIC switch delivers fast, wideband signal routing from DC to 30 GHz, with superior power handling, quick switching, and cost advantages over SOI devices...