Antenna-Based Control System Can Stop A Train

June 17, 2009
BLOOMINGDALE, ILTechnology exists to design a system that can start applying a train's brakes if an engineer fails to obey stop signals. Positive Train Control (PTC), a system that monitors railroads through a wireless network, can help to ...

BLOOMINGDALE, ILTechnology exists to design a system that can start applying a train's brakes if an engineer fails to obey stop signals. Positive Train Control (PTC), a system that monitors railroads through a wireless network, can help to prevent train crashes and enhance railroad safety. Currently used in several pilot programs, PTC systems will be required under the federal Railroad Safety Improvement Act (RSIA). Antennas are a critical component in the PTC system.

PTC refers to a flexible wireless system of monitoring train data including location, speed, track information, and equipment functioning. Information that is often gathered with the help of a Global Positioning System (GPS) is used to warn train operators about safety hazards. If necessary, the system can automatically slow or stop trains. With PTC, information is sent from the train to antennas placed trackside, where the data is relayed through another wireless system to the dispatch control center.

The RSIA, which was approved in October 2008, requires the biggest (Class I) freight companies, inter-city passenger, and commuter trains to implement PTC systems by 2015. According to the Federal Railroad Administration (FRA), a variety of components are needed ranging from digital data network to GPSs, on-board and dispatch computers, and throttle-brake interfaces.

The term "positive train control system" means a system designed to prevent train-to-train collisions, over-speed derailments, and incursions into established work-zone limits as well as the movement of a train through a switch left in the wrong position. Nine different railroad companies have PTC pilot programs in the US. Implementing the system nationwide in accordance with RSIA will require installing antennas in most railroad systems.

See associated figure

Sponsored Recommendations

Wideband Peak & Average Power Sensor with 80 Msps Sample Rate

Aug. 16, 2024
Mini-Circuits’ PWR-18PWHS-RC power sensor operates from 0.05 to 18 GHz at a sample rate of 80 Msps and with an industry-leading minimum measurement range of -40 dBm in peak mode...

Turnkey Solid State Energy Source

Aug. 16, 2024
Featuring 59 dB of gain and output power from 2 to 750W, the RFS-G90G93750X+ is a robust, turnkey RF energy source for ISM applications in the 915 MHz band. This design incorporates...

90 GHz Coax. Adapters for Your High-Frequency Connections

Aug. 16, 2024
Mini-Circuits’ expanded line of coaxial adapters now includes the 10x-135x series of 1.0 mm to 1.35 mm models with all combinations of connector genders. Ultra-wideband performance...

Ultra-Low Phase Noise MMIC Amplifier, 6 to 18 GHz

July 12, 2024
Mini-Circuits’ LVA-6183PN+ is a wideband, ultra-low phase noise MMIC amplifier perfect for use with low noise signal sources and in sensitive transceiver chains. This model operates...