EM Propulsion Grants Satellites Wireless-Power-Transfer Capability

Aug. 30, 2013
Scientists are testing electromagnetic-formation flight technology, which would use EM forces to reposition satellites while enabling wireless power transfer.

If a new electromagnetic (EM) propulsion technology lives up to its potential, it will revolutionize the capabilities of satellites and future spacecraft. Scientists at the University of Maryland’s Space Power and Propulsion Laboratory (SPPL) are currently working on the Resonant Inductive Near-field Generation System (RINGS), which could reduce the reliance on propellants via a renewable power source. They also are working on a demonstration of wireless power transfer. A finite propellant payload is one of the main limiting factors in terms of how many times a satellite can be repositioned once in space. A renewable, on-board electromagnetic power source, which doesn’t rely on propellants, could greatly extend a satellite’s lifespan and provide greater scientific return.

Essentially, RINGS could enable electromagnetic formation flight (EMFF), which uses locally generated electromagnetic forces to position satellites and spacecraft without the use of propellants. The wireless-power-transfer technology uses EMFF to reposition satellites, providing a means to wirelessly transfer power between spacecraft and power a smaller fleet. Such wireless-power-transfer capability could also provide the flexibility to perform formation control maneuvers, such as the creation of synthetic aperture arrays. Those arrays--a collection of smaller antennas that function as a collective larger antenna--may then be capable of producing higher-resolution images and better-quality data.

RINGS is composed of two units. Each one contains a specially fabricated coil of aluminum wire, which supports an oscillating current to 18 A and is housed within a protective polycarbonate shell. While aluminum was chosen for its low density during the research phase, the systems that are actually implemented will use superconducting wires to increase range and performance.

The system has already achieved a successful demonstration of EMFF in full 6 deg. of freedom. Most recently, RINGS was sent to the International Space Station as part of a payload launched on Japan’s HTV-4 Cargo Ship from the Tanegashima Space Center.. The RINGS project is a collaborative effort between UMD SPPL and partners from the Massachusetts Institute of Technology (MIT) and Aurora Flight Sciences (AFS).

About the Author

Iliza Sokol | Associate Digital Editor

Iliza joined the Penton Media group in 2013 after graduating from the Fashion Institute of Technology with a BS in Advertising and Marketing Communications. Prior to joining the staff, she worked at NYLON Magazine and a ghostwriting firm based in New York.

Sponsored Recommendations

Wideband MMIC LNA with Bypass

June 6, 2024
Mini-Circuits’ TSY-83LN+ wideband, MMIC LNA incorporates a bypass mode feature to extend system dynamic range. This model operates from 0.4 to 8 GHz and achieves an industry leading...

Expanded Thin-Film Filter Selection

June 6, 2024
Mini-Circuits has expanded our line of thin-film filter topologies to address a wider variety of applications and requirements. Low pass and band pass architectures are available...

Mini-Circuits CEO Jin Bains Presents: The RF Engine of the 21st Century

June 6, 2024
In case you missed Jin Bains' inspiring keynote talk at the inaugural IEEE MTT-S World Microwave Congress last week, be sure to check out the session recording, now available ...

Selecting VCOs for Clock Timing Circuits A System Perspective

May 9, 2024
Clock Timing, Phase Noise and Bit Error Rate (BER) Timing is critical in digital systems, especially in electronic systems that feature high-speed data converters and high-resolution...