NoiseWave Announces Coax Noise Source

Oct. 25, 2007

NoiseWave has introduced the model NW2G-CS coaxial noise source for built-in-test-equipment (BITE) and noise-measurement applications from 10 kHz to 2 GHz. Available in versions with excess noise ratios (ENRs) of 6, 15, and 30 dB, the noise source features better than +/-1 dB noise flatness with frequency. It draws 20 mA current from a +28-VDC supply and can be supplied with a variety of different coaxial connectors. The noise source measures just 0.75 x 0.50 x 1.25 inches without connectors.

NoiseWave (www.noisewave.com)

Continue Reading

Picking Proper PCB Materials For LNAs

Opting for Single-Layer or Multilayer Capacitors

Sponsored Recommendations

UHF to mmWave Cavity Filter Solutions

April 12, 2024

Cavity filters achieve much higher Q, steeper rejection skirts, and higher power handling than other filter technologies, such as ceramic resonator filters, and are utilized where...

Wideband MMIC Variable Gain Amplifier

April 12, 2024

The PVGA-273+ low noise, variable gain MMIC amplifier features an NF of 2.6 dB, 13.9 dB gain, +15 dBm P1dB, and +29 dBm OIP3. This VGA affords a gain control range of 30 dB with...

Fast-Switching GaAs Switches Are a High-Performance, Low-Cost Alternative to SOI

April 12, 2024

While many MMIC switch designs have gravitated toward Silicon-on-Insulator (SOI) technology due to its ability to achieve fast switching, high power handling and wide bandwidths...