Mixed-Signal Baseband IC Cuts Power Consumption At 60 GHz

Aug. 14, 2012
A lot of attention is being given to the 7-GHz bandwidth available in the 60-GHz band—largely with the hope of achieving multi-gigabit-per-second wireless links.

lot of attention is being given to the 7-GHz bandwidth available in the 60-GHz band—largely with the hope of achieving multi-gigabit-per-second wireless links. But today’s 60-GHz radios often are modeled on their lower-frequency brethren. For instance, they rely on orthogonal frequency division multiplexing (OFDM), which demands relatively high circuit and signal-processing complexity. This results in system partitioning and baseband power dissipation of roughly 1 W. A more optimal approach is the low-power, mixed-signal, adaptive 60-GHz baseband-radio integrated circuit (IC) that has been presented by Antoine Frappé from France’s IEMN-ISEN together with Chintan Thakkar, Lingkai Kong, Kwangmo Jung, and Elad Alon from the University of California at Berkeley.

This baseband device, which is implemented in 65-nm CMOS, operates at 10 Gb/s with a bit error rate (BER) of better than 10−12 while consuming either 53 mW (with adaptation on) or 45 mW (without adaptation). The key is its use of relatively low-dynamic-range analog signal processing. The baseband circuit integrates variable-gain amplifiers, an analog phase rotator, and more. The core signal-processing circuits consume just 29 mW. See "A 10 Gb/s 45 mW Adaptive 60 GHz Baseband in 65 nm CMOS," IEEE Journal Of Solid-State Circuits, April 2012, p. 952.

Sponsored Recommendations

Frequency Modulation Fundamentals

March 14, 2024
The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

March 14, 2024
The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

50W SSPA with Built-In Signal Source & Control

March 14, 2024
The RFS-2G42G5050X+ takes Mini-Circuits robust line of solid state, connectorized, high-power amplifiers for RF energy to a new level by integrating the versatility of a signal...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Feb. 19, 2024
Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...