Mwrf 11093 Fractal Tv Antenna
Mwrf 11093 Fractal Tv Antenna
Mwrf 11093 Fractal Tv Antenna
Mwrf 11093 Fractal Tv Antenna
Mwrf 11093 Fractal Tv Antenna

Tree Shape Helps Trim Size of Fractal Antenna

June 21, 2019
A fractal antenna shaped as a tree trims the amount of conductive metal required on PCB material compared to conventional patch antennas.

Antennas are important components in many systems, although they often add considerable size and weight. In their efforts to shrink the size and weight of RF/microwave antennas for spaceborne applications and wearable electronic devices, researchers from the University of Texas at Austin and Texas State University developed a miniaturized, tree-shaped fractal antenna (FA) on a flexible circuit material. It’s approximately one-half the size of a standard rectangular patch antenna designed for the same frequencies.

The antenna is fabricated on commercial, flexible circuit substrate material using conductive metal (silver) ink and a material inkjet printer capable of producing repeatable features as fine as 20 μm. The V-shaped branches of the antenna’s tree structure, which are unit cells with very repetitive behavior, do not require much space on the substrate material. The antenna is fed by a 50-Ω coplanar-waveguide (CPW) transmission-line section with filleted grounds to reduce the size of the antenna’s metal footprint and increase the antenna’s bandwidth by providing in-phase reflections from ground at more frequencies. Impedance matching to the antenna is performed by a tapered CPW transmission line.

Various iterations of the antenna were simulated, fabricated, and measured with commercial simulation software and test equipment. This was done to better understand the effects of dimensional changes on frequency and how the number of branches in a printed tree structure would impact the assorted frequencies and performance levels of the antennas. Many different resonant frequencies and bandwidths were studied, including a bandwidth of 2.83 GHz at 16 GHz and a bandwidth of 2.05 GHz at 7.71 GHz.

Most antenna configurations resulted in respectable gain at the resonant frequency. In all cases, the tree-shaped FAs were fabricated with significant reduction in metal ink compared to standard rectangular patch antennas, with much smaller metal footprints and smaller antenna sizes. Thus, these antennas make strong candidates for wearable electronic devices throughout the RF/microwave frequency range. 

See “A Miniaturized Tree-Shaped Fractal Antenna Printed on a Flexible Substrate,” IEEE Antennas and Propagation Magazine, June 2019, pp. 60-66.

Sponsored Recommendations

Frequency Modulation Fundamentals

March 14, 2024
The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

March 14, 2024
The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

50W SSPA with Built-In Signal Source & Control

March 14, 2024
The RFS-2G42G5050X+ takes Mini-Circuits robust line of solid state, connectorized, high-power amplifiers for RF energy to a new level by integrating the versatility of a signal...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Feb. 19, 2024
Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...