Analog Signal Generators Cut Noise Levels

July 31, 2007
The SMB100A line of analog signal generators from Rohde & Schwarz is designed for ease of use and high performance through 6 GHz. Four models provide frequency ranges of 9 kHz to 1.1 GHz, 9 kHz to 2.2 GHz, 9 kHz to 3.2 GHz, and 9 kHz to 6 GHz. They ...

The SMB100A line of analog signal generators from Rohde & Schwarz is designed for ease of use and high performance through 6 GHz. Four models provide frequency ranges of 9 kHz to 1.1 GHz, 9 kHz to 2.2 GHz, 9 kHz to 3.2 GHz, and 9 kHz to 6 GHz. They deliver +18 dBm output power and over-range power levels to +25 dBm. The output-power flatness is within 1 dB to 3 GHz and better than 2 dB at frequencies above 3 GHz. The phase noise is typically -128 dBc/Hz offset 20 kHz from a 1-GHz carrier. The wideband noise is typically -152 dBc at 1 GHz. For more information, visit the R & S site at: http://www.rohde-schwarz.com

Sponsored Recommendations

Frequency Modulation Fundamentals

March 14, 2024
The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

March 14, 2024
The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

50W SSPA with Built-In Signal Source & Control

March 14, 2024
The RFS-2G42G5050X+ takes Mini-Circuits robust line of solid state, connectorized, high-power amplifiers for RF energy to a new level by integrating the versatility of a signal...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Feb. 19, 2024
Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...