The Cobra Judy Replacement program is tasked with delivering a high-performing ship-board radar capability for use by the US Navy, Air Force, and the nation.

Cobra Judy Replacement Radars Pass Test

May 4, 2013
The Cobra Judy Replacement program is tasked with delivering a high-performing ship-board radar capability for use by the US Navy, Air Force, and the nation.

Next January, the Cobra Judy Replacement (CJR) program will begin providing the United States government with long-loiter, ballistic-missile data-collection capability in support of international treaty verification. The program recently underwent its first tests against a live rocket launch. From approximately 100 miles off the Florida coast, the powerful X- and S-band radars integrated on-board the USNS Howard O. Lorenzen (T-AGM 25; see photo) successfully acquired and tracked both stages of an Atlas V rocket launched from Cape Canaveral. They also collected all associated data.

With this demonstration, CJR validates its mission capability, advancing the program on schedule toward Initial Operational Capability (IOC). This live-launch exercise follows a series of achievements for the radar suite. Raytheon, prime contractor for the CJR mission equipment and principal, completed the ship-board installation of CJR mission equipment in late 2011 at Kiewit Offshore Services in Corpus Christi, TX. In late 2012, full-power radiation capability was demonstrated for the high-sensitivity shipboard X- and S-band radars. In addition, dual-band satellite acquisition and tracking was successfully performed under the control of the CJR common radar suite controller.

The CJR large-scale, complex dual-band radar suite consists of X- and S-band phased-array sensors, a common radar suite controller, and other related mission equipment. The X- and S-band active phased-array antennas are each approximately four stories tall and weigh more than 500,000 lbs. This program replaces the original Cobra Judy, USNS Observation Island, which has been in service since 1981. 

Sponsored Recommendations

UHF to mmWave Cavity Filter Solutions

April 12, 2024
Cavity filters achieve much higher Q, steeper rejection skirts, and higher power handling than other filter technologies, such as ceramic resonator filters, and are utilized where...

Wideband MMIC Variable Gain Amplifier

April 12, 2024
The PVGA-273+ low noise, variable gain MMIC amplifier features an NF of 2.6 dB, 13.9 dB gain, +15 dBm P1dB, and +29 dBm OIP3. This VGA affords a gain control range of 30 dB with...

Fast-Switching GaAs Switches Are a High-Performance, Low-Cost Alternative to SOI

April 12, 2024
While many MMIC switch designs have gravitated toward Silicon-on-Insulator (SOI) technology due to its ability to achieve fast switching, high power handling and wide bandwidths...

Request a free Micro 3D Printed sample part

April 11, 2024
The best way to understand the part quality we can achieve is by seeing it first-hand. Request a free 3D printed high-precision sample part.