cablepowerpromo.jpg
cablepowerpromo.jpg
cablepowerpromo.jpg
cablepowerpromo.jpg
cablepowerpromo.jpg

Receiving System Converts RF to DC

Aug. 1, 2016
A six-antenna array and RF-to-dc conversion circuit can efficiently collect otherwise wasted RF energy in a room.
Download this article in .PDF format
This file type includes high-resolution graphics and schematics when applicable.

Changing energy from one form to another, such as solar radiation from sunlight to dc voltage, can help meet the growing global demands for energy in the years ahead. In the near term, it is also a practical means of providing power for remote sensors and other electronic devices that must be “set and forget” as part of Internet of Things (IoT) applications.  Even when such devices are in standby mode, awaiting a signal, they consume energy and require a power source.

With this goal in mind, French researchers sought an alternative to a single omnidirectional antenna for collecting what RF energy was present in a room, such as in a home or factory setting. They developed a system that combines six parasitic element antennas (PEAs) and RF-to-dc converter circuits to transform RF energy into dc voltage.

Given the growing number of wireless devices, from smartphones, tablets, and other mobile devices connected to a small cell, base station, or Wi-Fi gateway, the amount of “discarded” RF/microwave EM radiation is enormous and readily available for scavenging and reuse. Many RF-to-dc conversion circuits have been developed for this purpose, but they have been hampered by the limited efficiency of their antennas, otherwise known as “rectennas.”

The researchers focused on boosting the efficiency of an RF-to-dc home-automation system by improving the performance of an array of six rectennas within a room. Their solution was to take a cellular approach to energy harvesting within the room, combining printed-circuit-board (PCB) rectennas with RF-to-dc-conversion circuits on the same circuit board, about the size of a credit card.

Developed for use at 2.45 GHz, the compact energy-harvesting system was designed, manufactured, and tested, and found to be capable of providing enough energy to maintain additional circuits, such as an RF switch. The researchers performed simulations and computed that the system would deliver different amounts of energy based on room size; for example, 1723 and 880 mV, respectively, for rooms measuring 5 × 5 m and 10 × 10 m.

See “Multidirectional Receiving System for RF to dc Conversion Signal,” IEEE Antennas & Propagation Magazine, Vol. 58, No. 3, June 2016, p. 22.

Sponsored Recommendations

Frequency Modulation Fundamentals

March 14, 2024
The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

March 14, 2024
The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Feb. 19, 2024
Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...

Using a CMT VNA with Socket Server

Feb. 19, 2024
This application note describes use of a software application CMT Socket Server which is distributed and supported by Aphena Ltd. Please email [email protected] regarding purchase...