Amp Lowers Noise By A Wide Range (.PDF Download)

Aug. 29, 2013

Noise can block signals in a receiver and limit the lower end of the system’s dynamic range. For that reason, system designers usually specify a front-end low-noise amplifier (LNA) for the receiver with reasonable small signal gain, so as to ...

Register or Sign in below to download the full article in .PDF format, including high resolution graphics and schematics.

Sponsored Recommendations

Frequency Modulation Fundamentals

The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...

Using a CMT VNA with Socket Server

This application note describes use of a software application CMT Socket Server which is distributed and supported by Aphena Ltd. Please email [email protected] regarding purchase...