6 Degrees of Microwave and RF/Microwave Switch Separation (.PDF Download)

May 8, 2015

Before electronic control and actuation, mechanically actuated RF switches were used to re-route RF energy to different subsystems. Out of necessity, these switches were often custom, expensive, slow, and prone to failure. But they could handle significant amounts of RF energy...

Register or Sign in below to download the full article in .PDF format, including high resolution graphics and schematics when applicable.

Sponsored Recommendations

Frequency Modulation Fundamentals

The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...

Using a CMT VNA with Socket Server

This application note describes use of a software application CMT Socket Server which is distributed and supported by Aphena Ltd. Please email [email protected] regarding purchase...